To Replace Paddles:
- Remove end caps by prying out with a small screw driver or similar tool.
- Remove Phillips head screw
- Slide Paddle off Handle Post
- One bearing will likely remain at the bottom of the post. The top bearing will slide off with the paddle remaining inside
- Remove one or both bearings from the paddle by pushing out from the opposite end.
- Install replacement paddle in the following order:
- Bearing
- Paddle
- Bearing
- Screw
- Cap
Be sure top bearing is seated down over the handle post before installing screw. Screw will tighten but excess play in the paddle will occur if the bearing is sitting on top of instead of over the post.
Click HERE to shop ALL Lew's Products!